List Of Parameters - abc PU00 Manual

Warning Alarm
u.57 A.57
u.62 A.62
u.66
A.69
u.75
u.76 A.76
EN
A.99
Parameter
Number
Parameter Group 0：General Control Mode and Commands
P0-01 Control Mode
Motor Control
*P0-02
Principle
P0-03 Macro-program
*P0-04 Torque Characteristics
Motor Speed
*P0-05
Direction
Error Fault Name
Analogue input
terminals Error
Communication
Timeout
Motor Loss
Mechanic Brake
Current Low
Drive License
Timeout
External alarm
CU
Er.90 communication
Timeout
Parameter change
Er.93
disabled
Parameter change
Err
disabled
AMA Error

7. List of Parameters

Parameter Name
0: Speed Mode Speed Sensor less
1: Speed Mode with Speed Sensor
2: Torque Mode Speed Sensor less
3: Torque Mode with Speed Sensor
0: V/F; 1: Vector Control 1;
2: Vector Control 2
0：Invalid；1：Pump Control； 2: Easy PLC
0：CT; 1：VT; 9：AEO
0：Clockwise; 1：Anticlockwise
2：Bidirectional
Reason Description
1. Wire connection
problem
2. The parameters for
AI1/AI2 live zero are not
correctly set
Drive communication
timeout (with external
controller PC/PLC/HMI
etc.)
1. External controller
abnormal
2. communication line
connection problem
3. communication
Parameters(P0-8X)
incorrect.
4.EMC problem.
Motor cable connection
or motor problems;
Actual motor current
cannot exceed release
brake current
(P1-97~P1-98) within
start delay time.
Drive License Timeout
function activated
DI terminals select
external alarm function
CU Failed to
communicate with PU
1. They keypad was
locked when changing
the parameters
2. parameters over the
range
The parameter cannot be
changed when Drive
running
Failed to finish the motor
parameter auto tuning
Value Range
44
Suggested Handling
1. Check the wire
connection
2. Adjust the relevant
parameter setup
1. Check external
controller PC, PLC, HMI
etc. 2.Check
communication line
connection 3.Correctly set
communication
parameters(P0-8X) 4.
wiring the communication
cables correctly, including
shielding and grounding
5.Contact our local support
or Company
Check motor cable or motor
phase
Correctly set mechanical
brake
parameters(P1-97~P1-98)
Contact our local support or
ABC Company
Check external alarm
source
1.Power off, then confirm
the installation between PU
and CU
2.Contact our local support
or ABC Company
1. deblock the keypad
2. set the parameters
correctly
Change the parameter after
Drive stop
Correctly set motor
parameters according to
motor nameplate
Factory
Unit
Default
0
1
0
0
2