Table of Contents
Advertisement
Resolving Conflicts
in Windows Me/98
SE
If you are unsure of
which peripheral
device is causing the
conflict, you can
isolate the source of
the difficulty by
temporarily removing
all devices (except
your PC Card and
essential devices such
as the disk controller).
After that, add the
devices back one at a
time until the device
that is causing the
conflict is found.
Difficulties
with Your PC
Card
To run Device Manager:
1.
Click Start -> Settings -> Control Panel.
2.
Click the System icon. The System Properties dialog box appears.
3.
Click the Device Manager tab.
4.
Double-click Modem.
5.
Select your PC Card and click the Properties button. The Properties dialog
box of the PC Card appears.
6.
Click the Resources tab.
7.
Click the Use Automatic Settings check box to select it. If this check box is
already selected, you need to go to the Properties dialog box of the
conflicting peripheral device and select the same check box there.
8.
Restart your system to allow Windows Me/98 SE to reassign resources to your
PC Card and/or the conflicting peripheral device.
The PC Card fails to accept commands to dial or answer a call.
There may be an improper telephone line connection.
Check the following:
• Make sure the telephone adapter cord is attached to the RJ-11 port.
• Check that all devices are turned on.
There is interference on the telephone line that is connected to the PC
Card.
To resolve this difficulty:
Troubleshooting B-3
Advertisement
Table of Contents
