Table of Contents
Advertisement
Operating instructions
POWER key
EQUALIZER key
KENWOOD aunto-vined STEREO RECEIVER KR-v39020
CD DIRECT indicator
r74
OIRECT
FW
AM
PECAN I-20
Point indicator
MOIOITAL DELAY SURNOUND SYSTEM
VOLUME
CONTROL
knob
PHONES
EQUALIZER LEVEL WCuO.EG/9PI,
EQREC
POAT Ez
4
EQUALIZER control keys
STAND
BY mode of POWER
key
When the power cord of this system is plugged into an
AC outlet, the STAND BY indicator lights up regardless
of the ON/OFF
setting
of the
POWER
key. This
indicates
that a small
amount
of current
is being
supplied to the unit to back up the memory contents.
This mode is referred to as the Stand By mode. While
the STAND BY indicator is lit, the power of the system
can be switched ON/OFF from the remote control unit.
To mute the sound temporarily
Press the MUTE
key.
® The point indicator blinks, and the output is muted.
@ When the MUTE key is pressed again, the muting is
canceled, the point indicator lights steadily and the
previous output level is resumed.
The mute mode can also be released by changing the
output level using the remote control unit.
® The point indicator also blinks (for approx. 4 seconds)
when the muting functions is engaged immediately
after the power is turned ON.
18
kRv9020 (En)
Input selector keys
BALANCE knob
@ Basic operation
1.
Press the POWER
key to ON.
© The display lights and the unit becomes operative.
© Pressing the key again switches the power OFF.
. Press one of the input selector keys to select the input
source to be played.
© If a System Control cord has been connected to the
selected source component,
it starts play automati-
cally due the Automatic Play operation feature.
© With the Automatic Play operation feature, when one
of the source components is started to be played, the
corresponding
input
selector
is
automatically
switched for the source.
® The selected input source is shown on the display.
. If automatic play operation using the System Control
cords has not been set, start playing the source com-
ponent selected.
. Adjust the output level with the VOLUME
CONTROL
knob.
@ When
one of the VOLUME
CONTROL
keys on the
remote control unit is pressed, the point indicator
blinks and the VOLUME CONTROL knob is rotated.
. Adjust the balance of the left and right output levels
with the BALANCE knob.
. Adjust the tone
referring
to the description
in the
"Graphic equalizer" section.
@ The graphic equalizer effect can be switched
ON/
DEFEAT by pressing the EQUALIZER key.
Notes:
1.
2.
The CD DIRECT key should usually be set to OFF (with the
indicator not lit).
When
the TAPE-2
selector switch
is set to ON, the input
source selected with the input selector keys cannot be heard
from the speakers. To listen to a source other than tape deck
2, be sure to set the TAPE-2 selector key to OFF.
Advertisement
Table of Contents
