Table of Contents
Advertisement
FM outdoor antenna
Be sure to use an outdoor FM antenna to receive good
sound quality FM broadcasts with a minimum of noise.
When
connecting
an outdoor
antenna
to the antenna
terminals of this unit, use a 75 ohm/300
ohm antenna
adaptor connected to the coaxial cable as illustrated. The
75 ohm/300 ohm antenna adaptor is supplied with this
unit. Be sure to connect the coaxial cable to the adaptor
as instructed below.
Note:
——_———$S
An FM outdoor antenna can be connected to the receiver with
either a 75 ohm coaxial cable or a 300 ohm ribbon feeder. For
proper connection,
carefully read the instruction
manual
pro-
vided with outdoor antenna.
@ 75 ohm coaxial cable connection (Follow the order of numbers.)
Arrange the coaxial
cable as illus-
trated.
tenna adaptor cover.
Press the claws in the direction of
the arrows with the fingers to re-
lease the lock and pull out the cover.
Outer shield
(Braid)
=
Inner
conductor
RG-6 (5C-2V) or RG-59 (3C-2V)
Connect the processed coaxial ca-
ble to 75 ohm/300
ohm antenna
adaptor as shown below.
Insert the inner conductor
into the slot on the clip.
Wire mesh
Channel
Space Frq.
DE-EMPHASIS
U.S.A.
FM:
Canada and
South Ameri-
AM:
10 kHz
can
countries
100 kHz
Other
countries
FM DE-EMPHASIS/CHANNEL
SPACE table
75 us
A !OkHz
1OOkHz
5Ous
9kHz
SOkHz
AM
FM
DE -
EMPHASIS
CHANNEL
SPACE
Open
the 75
ohm/300
ohm
an-
Cut off the red wire and remove it
from the clip.
//
Remove the
\
red wire
MFM
DE-EMPHASIS/CHANNEL
SPACE
switch (Except for some areas.)
The FM DE-EMPHASIS/CHANNEL
SPACE switch on the
rear panel is set to the correct setting that prevails in the
area to which the unit is shipped. However,
if the FM
DE-EMPHASIS/CHANNEL SPACE setting is not matched
to the area where the unit is to be used (for instance. if you
move
from
area
1 to area
2 or vice versa), desired
reception of AM/FM
broadcasts cannot be expected. In
this case,
change
the
FM
DE-EMPHASIS/CHANNEL
SPACE setting in accordance with the area corresponding
to the table on the left.
The FM DE-EMPHASIS
setting is switched
over at the
same time.
Note:
————————__
eee
When changing the setting of the FM DE-EMPHASIS/CHANNEL
SPACE switch, first disconnect the power cord, then reset the
channel space switch, connect the power cord again. and turn
the power on.
KR-V9020 (En)
11
Advertisement
Table of Contents
