Table of Contents
Advertisement
LEARN
J)
(SSytransmit
LEARN ,, USE
aun10¥I2EO aux
Set to USE.
Overlay sheet
@ To erase the entire programmed
contents
With
a single procedure,
you can
erase
all of the
remote
control
functions
which
have
been
pro-
grammed under keys in each mode (AUDIO, VIDEO,
and AUX).
1. Set the LEARN/USE switch to the LEARN position.
2. Press a programmable key (any programmable key
may be pressed).
@ The LEARN indicator lights.
. Remove
the battery cover from the back of the
remote control unit.
. Press the reset key located inside the battery case
using the tip of a ball-point pen or similar instrument.
® All of the programmed
contents are erased and
the remote control unit returns to its initial condi-
tion.
Reset key
@ To check the programmed contents dur-
ing programming
1. Check that the LEARN/USE select switch is in the USE
position.
2. Press the key to be checked.
3. Verify
that the
component
to be operated
works
correctly.
@ To change the programmed contents
Perform the programming operation again. The previously
programmed contents will be canceled automatically, and
the newly programmed
contents will be maintained
in
memory.
@ Normal
operation
of the remote
control
unit
. Set the LEARN/USE select switch to the USE position.
2. Press a key under which another remote control func-
tion has been programmed.
The TRANSMIT indicator blinks and the target compo-
nent operates as intended.
_
@ Overlay sheet
The provided overlay sheet offers a convenient way to
record and recall the contents programmed
under the
various operation keys.
Write the programmed key contents on the overlay sheet
with an oil-based felt-tipped marker or pencil. To erase,
use a conventional eraser.
Most audio/video components use the same infrared
remote control coding system. Therefore, the RC-120
can memorize most of the functions of other remotely-
controlled components.
Please read this manual and
the instruction manuals provided with your other A/V
components carefully before programming the remote
control functions of the other components.
Notes:
—
1. If the optical output level of the other remote control unit is
high, programming
may not be carried out correctly. If this
occurs, separate the RC-120 and the other remote control
unit by a greater
distance
and
perform
the programming
procedure again.
2. If the LEARN and TRANSMIT
indicators blink simultaneously
during programming, this indicates either that the key being
programmed cannot be programmed or that programming has
not been performed completely. If this occurs, perform the
programming procedure again.
3. Remote
control
functions
using specially-coded
signals or
signals other than infrared signals cannot
be programmed.
Programming is also impossible when the RC-120's memory
capacity becomes full.
4. The LEARN
indicator goes out 30 seconds after a learning
(programmable)
key is pressed. After this, programming
is
impossible.
To continue
programming,
press
the learning
(programmable) key again.
5. When two or more learning (programmable) keys are pressed
at the same time, the remote control function of the other
remote control unit will be stored under the key which was
pressed last.
6. Do not program the remote contro! functions of equipment
other than A/V components, such as air conditioners, etc.
KR-V9020 (En)
41
Advertisement
Table of Contents
