Table of Contents
Advertisement
| 78 |
66 MHz
OFF
OFF
| 100 MHz
133 MHz
* Default
Example:
Using a C3 CPU with front side bus frequency of 133MHz and PC-133
SDRAM module, the setting of JPMI1 will be all OFF. Will form CPU BUS
CLOCK be 133MHz.
For experience user looking for over clocking, please refer to sec 2-3-4
2-3-3
Install CPU
This motherboard provides a ZIF socket 370.
The CPU
that comes
with the
motherboard should have a cooling FAN attached to prevent overheating. If this is not
the case, then purchase a correct cooling FAN before gon turn on your system.
WARNING!
Be sure that there is sufficient air circul
mn act
heatsink and CPU cooling FAN is working 'cor
may cause the processor and motherboard overheat and damage,
you may install an auxiliary cooling FAN, if necessary.
To install a CPU, first turn off your system and remove its cover.
Locate the ZIF
socket and open it by first pulling the level sideways away from the socket then
upward to a 90-degree angle.
Insert the CPU with the correct orientation as shown
below.
The notched corner should point toward the end of the level.
Because the
CPU has a corner pin for two of the four corners, the CPU will only fit in the
orientation as shown.
Socket 370
8
Advertisement
Table of Contents
