Troubleshooting - FoodSaver FFS015X-01 User Instructions

Troubleshooting

Problem
Overheat warning light
comes on
Pump operates for more than
2 minutes without air being
removed.
Bag is not sealing properly.
Nothing happens when latch
is closed and Vacuum and Seal
button or Seal Only button is
pressed.
If you need further assistance:
Solution
• The unit has overheated. Wait until the overheat warning light goes out before
O
using.
• Make sure the open end of the bag is inserted into the drip tray.
• Check to make sure both gaskets are fitted properly.
• Check to make sure that at least one end of the bag is sealed.
• Open the unit and check to make sure that there are no foreign objects, dirt or
debris on the upper or lower gaskets.
• Make sure there is enough room at the top of the bag (75 mm) so it will fit into the
drip tray with lid closed and latched.
• Make sure the handheld sealer is not attached.
• Make sure the lid is fully closed (the green band is showing around the latch and
the green power light is on).
• There is too much liquid in the bag. Freeze the bag contents before vacuuming.
• To prevent wrinkles in the seal, gently stretch the bag flat while inserting the bag
into the drip tray and continue to hold bag until vacuum pump starts.
• Create a second seal above the first seal on the bag to ensure a proper seal when
sealing moist foods.
• Make sure the lid is fully closed (the green band is showing around the latch and
the green power light is on).
• Please visit www.foodsavereurope.com.
www.foodsavereurope.com
11