Table of Contents
Advertisement
Logging
VBOX Touch logs data via an SD card inserted into the side of the unit. Depending on the Logging Strategy selected
within the
General Settings
Tapping on the
SD Card Icon
Strategy.
The
Record Icon
will show when the unit is logging data to the SD card.
If you have come to a stop, but the Record Icon is still on, press the SD Card Icon to stop the logging before removing
the card.
Sometimes, due to poor satellite visibility in a garage or close to a building, the box may start recording, even if the car is
stationary. Always check the Record Icon before ejecting the card.
IMPORTANT
Do not remove the SD card when the Record Icon is on as you may lose data.
Note: If for some reason the SD card is removed while the unit is still recording, it may need to be repaired using a PC
before it can be reused.
Logging Switch
You can also control the logging by using an RLVBACS010 hand-held latching trigger switch (unlatched for logging/
latched for not logging). Continuous Logging Mode should be selected when using the switch. It is connected to the
3-pin
Digital In and PPS Connector
When the trigger switch is connected and latched, it is not possible to use the SD Card Icon to manually start or stop
logging data.
Logged Channels
VBOX Touch logs channels to an inserted SD card within a
• Satellites: This is the number of satellites in use.
• Time: This is UTC since midnight in the form HHMMSS.SS.
• Latitude: Latitude in minutes MMMM.MMMMMMMM +ve = North e.g. 3169.30644410M = 52D, 49M, 18.4S.
• Longitude: Longitude in minutes MMMMM.MMMMMMMM +ve = West e.g. 00040.18164742M = 00D, 40M, 10.9S.
area, the unit will either log continuously or when movement is detected (default).
when
green
will manually start or stop logging data, overriding the
on the side of the VBOX Touch.
.vbo
file, channel information is available below:
Configured Logging
4
Advertisement
Table of Contents
