Important Safeguards; Maintenance And Cleaning - Warmtech RCM2000TL Original Instructions Manual

IV Operation
1. Before use checks that the voltage power
corresponds to the one shown on the appliance's
nameplate.
2. Make sure you are using the suitable plug
3. Mechanical mode
3.1 Press the Start / Stop button once, the
machine starts to operate and blow cold air;
3.2 Press the On / Off button again, the unit
will blow hot air (1000W)
3.3 Press the On / Off button a third time,
the unit will blow the hotter air (2000W)
3.4 Press the On / Off button a fourth time,
the unit will stop working, turn the unit will start
working and blowing cold air. Option cycle.
4. Mechanical mode ( timer button)
4.1 From 01h to 8h . The
progress like here( 1h-2h-3h.....until to
get the 8h)
5 Remote control use; see photo 2
5.1 Push
5.2 Push FUNCTION button .for
1000W/2000W/cool air.
5.2 Push TIMER button , same as
the timer of the panel.
5.3 Push the SWING button, for
automatic oscillation lourvres and wide
angle hot blow.
button ,start working.
V

IMPORTANT SAFEGUARDS

The air outlet must be hanged downward on the
wall and horizontal. Do not install the appliance
differently or diagonally.
If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
Do not install the heater directly under the outlet.
Make sure that only suitble plug should be used.
Never operate the heater without supervision.
The appliance may not be operated in the proximity
of inflammable articles. If the fan does not run any
longer, the appliance should be stopped
immediately.
Unplug from the outlet when not in use and before
cleaning. Warning: During the operation do not
cover or contact the safety net.
This appliance is not intended for use by persons
(including children) with reduced physical ,sensory
or mental capabilities ,or lack of experience and
knowledge unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety"
Children should be supervised to ensure that they
do not play with the appliance.
VI Cleaning and maintenance

MAINTENANCE AND CLEANING


Before cleaning the appliance, ensure it is
disconnected from the power supply and has
cooled down completely.

The housing may be wiped with a slightly
damp, lint-fee cloth; do not use any abrasive
scouring pad or steel wool.

The grids are particularly delicate; to clean
them you can carefully use a vacuum cleaner.

When you do not use the appliance, you can
cover and place it in a dry environment.
12