Table of Contents
Advertisement
Minimum requirements:
Operating system
compatibility iOS 13/Android
10 and above. Install the
Electrolux Life app, create
an account and accept the
Terms and Conditions and
Electrolux's Privacy Policy to
use the connected features.
Stable Internet and good Wi-
Fi connection with 2.4GHz
wireless frequency is
required. Minimum
requirements, apps and
services are subject to
change without notice.
6.1 QR code on rating plate
Mod. xxxxxxxxx
Prod.No.
910000000 00
000V ~ 00Hz 0000 W
QR code can be used in two ways:
• Scan the QR code with the built-in
camera app to register your product.
• Pairing your smart device with
appliance to simplify the process.
Scan the QR code with QR code
scanner built-in Electrolux Life
application.
6.2 Installing Electrolux Life
When connecting the tumble dryer to the
application, stand near it with Your smart
device.
Make sure that your smart device is
connected to the wireless network.
1. Go to the App Store on your smart
device or scan QR code (
"QR code on rating plate" ).
2. Download and install App Electrolux
Life.
3. Make sure you started a Wi-fi
4. Start the application. Select the
6.3 Configuring the dryer
wireless connection
Have Electrolux Life downloaded and
installed on your smart device.
1. In the App - tap on Add appliance
2. Press the on/off button for a few
3. Select a program by turning the
4. Press and hold
SCANNING...
The text
and the icon
wireless module begins starting up. It
may takes about 10 seconds before it is
ready. When the wireless module is
ready, the text
to inform you, that the access point will
00A
00000000
be open for about 3 minute.
5. Configure the Electrolux Life app on
6. If the connectivity is configured,
see chapter
To switch the wireless connection
off,Press and hold
button for 3 seconds until the first
connection in the dryer. If not go to
the section below.
country and language and login with
Your email and password. If you do
not have an account, create a new
one following the instructions in
Electrolux Life.
and follow the instructions on the App
for appliance connection.
seconds to activate the appliance.
program dial.
Remote touch
button for 3 seconds.
pop up for about 5 seconds
starts flashing and
(Access Point) is on
your smart device.
(Access Point) symbol is off and the
icon
will stop blinking and lit
steadily to confirm that the
configuration was successful.
Every time you switch
the appliance on, the
appliance takes about 10
seconds to connect to
the network
automatically. When the
indicator
stops
blinking the connection
is ready.
Remote touch
ENGLISH
11
Advertisement
Table of Contents
