Table of Contents
Advertisement
Available languages
Available languages
OPERATION
Controls
The hood is operated using the slide controls
under the front edge of the hood.
The light switch
turns the halogen lights on
and off.
The blower on / offswitch
turns the blower on
to the running speed set by the blower speed
control. The blower must be turned on and off
using this switch.
The blower speed control changes the run-
ning speed of the blower. It is infinitely adjust-
able from low to high speed.
The pilot lamp lights up whenever the blower
is on.
LIGHT
SWmTCH
BLOWER
BLOWER
ON / OFF
SPEED
SWITCH
_.i_//
PILOT
_
LAMP
HEAT SENTRY
TM
Your hood is equipped with a HEAT SENTRY
TM
thermostat.
This thermostat is a
device that wilt turn on or speed up the blower if it senses excessive heat above
the cooking surface.
1) If blower is OFF - it turns blower ON to HIGH speed.
2) If blower is ON at a lower speed setting - it turns blower up to HIGH speed.
When the temperature
level drops to normal, the blower will return to its original
setting.
WARNING
The H EAT SENTRY thermostat
can start the blower even if the hood is turned
OFF. When this occurs, it is impossible
to turn the blower OFF with its switch.
If you must stop the blower, do it from the main electrical
panel.
HALOGEN
BULBS
This range hood requires four (4) halogen bulbs
(Type T3, 12Volt, 20Watt Max, G-4 Base).
ALWAYS SWITCH OFF THE ELECTRICITY
SUPPLY
BEFORE
CARRYING
OUT ANY
OPERATIONS ON THE APPLIANCE.
RING NUT
To change bulbs:
1. Loosen
the
ring
nut
by
turning
it
o
o
counterclockwise.
2. Remove the bulb by pulling sideward - DO
NOT ROTATE. CAUTION: BULB MAY BE HOT!
3. Replace with Type T3, 12Volt, 20Watt Max, G-4 Base halogen bulb. Do not
touch replacement
bulb with bare hands!
-11 -
Advertisement
Table of Contents
