Regulatory Notices; Fcc Class A Notice; Canadian Certification - Can Ices-3 (A)/Nmb- 3(A); Battery Cautions - Entrust nShield Solo Install Manual

Chapter 3. Regulatory notices

3. Regulatory notices

3.1. FCC class A notice
The nShield Solo and nShield Solo XC HSMs comply with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1. The device may not cause harmful interference, and
2. The device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the users will be required to correct the interference at
their own expense.
3.2. Canadian certification - CAN ICES-3 (A)/NMB-
3(A)

3.3. Battery cautions

Danger of explosion if the battery is incorrectly replaced. The battery may only be
replaced with the same or equivalent type. Dispose of the used battery in
accordance with your local disposal instructions.

3.4. Hazardous substance caution

This product contains a lithium battery and other electronic components and
materials which may contain hazardous substances. However, this product is not
hazardous providing it is used in the manner in which it is intended to be used.

3.5. Recycling and disposal information

nShield Solo and Solo XC v13.4 Install Guide 7/49