In Case Of Difficulty - Kenwood KR-V8040 Instruction Manual

In case of difficulty
What appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult
the table below to see if the problem can be corrected before seeking help from your dealer or service representa-
tive.
Remote control unit
Symptom
Remote control operation is not pos-
sible.
Amplifier, speakers
Symptom
Batteries are exhausted.
The audio cords and the system control
cords are not connected properly.
The remote control unit is too far away
from the main system, controlling angle |
is too large, or there is an obstacle in
between.
The source component to be operated
does not contain the analog disc,
tape(s) or CD.
An attempt is made to play a tape which
is being recorded in the cassette deck.
Sound is not output.
No sound comes out, and "PROTECT"
is shown on the display.
Sound is not output from one of the
speakers.
Sound is not output from the surround
rear speaker and / or center speaker,
or their sound is very small.
A hum noise is generated when the
PHONO input select key is pressed.
The speaker cords are disconnected.
The volume is set to the minimum posi-
tion.
The MUTING key is set to ON and the
point indicator is blinking.
Speaker cords are short-circuited.
The speaker cord is disconnected.
The BALANCE control is set to an ex-
treme position.
The rear speaker cords and/or center
speaker cord are disconnected.
The presence mode has not been en-
gaged.
The REAR LEVEL and/or CENTER
LEVEL controls are set to the minimum
level.
The audio cord from the turntable is not
inserted securely into the PHONO
jacks.
The turntable is not grounded.
Replace with new batteries.
Connect properly referring to "System
connections".
Operate the remote control unit within
the controllable range.
Place an analog disk, tape(s) or CD in
the source component to be played.
Wait until the recording is completed.
Connect them properly referring to
"System connections".
Adjust the volume to a proper level.
Press the MUTING key to OFF.
Turn the power off, eliminate the short-
circuiting, then turn on the power again.
Connect it properly referring to "Sys-
tem connections". —
Adjust the Left / Right balance.
Connect them properly referring to
"System connections".
Set the presence mode.
Adjust the REAR LEVEL and CENTER
LEVEL controls.
Insert the audio cord plugs securely into
the PHONO jacks.
Connect the grounding wire to the GND
terminal on the rear panel.
KR-V8040 (En} 35