Table of Contents
Advertisement
In case of difficulty
Remote control unit
Remote contro! operation is not possible.
we
=e
Amplifier section
Sound is not output.
No sound comes out, and "PROTECT" is
shown on the display.
Sound
is not output
from
one
of the
speakers.
Sound is not output from the Surround
rear speaker
and/or center speaker,
or
their sound is very small.
A
hum
noise
is generated
when
the
PHONO input selector key is pressed.
28 «R-va030 (En!
@ Batteries are exhausted.
@ The audio cords and the system
control
cords are not connected properly.
@ The remote
controi unit is too far away
from the main system, controlling angle is
too
large,
or
there
is an
obstacle
in
between.
@ The source
component
to be operated
does not contain the analog disk, tape(s)
or CD,
@ An attempt is made to play a tape which
is being recorded in the cassette deck.
@ The speaker cords are disconnected.
@ The
VOLUME
is set
to the
minimum
position,
@ The MUTING
key of the remote control
unit. is set to ON and the point indicator is
blinking.
@ Speaker cords are short-circuited.
@ The speaker cord is disconnected.
@ The
BALANCE
control
extreme position.
is
set
to
an
@ The
rear-speaker
cords
and/or
center
speaker cord are disconnected.
@ The Surround
play mode
has not been
engaged.
@ The REAR LEVEL and/or CENTER
LEVEL
controls are set to the minimum level.
@ The SPEAKER
IMPEDANCE
SELECTOR
on
the
rear
panel
is
set
to
the
SURROUND off side.
@ The audio cord from the turntable is not
inserted securely into the PHONO jacks.
@ The turntable is not grounded.
@ Replace with new batteries.
@ Connect
properly
referring
to
"System
connections'.
@ Operate
the remote
control
unit within
the controllable range.
@ Place an analog disk, tape(s) or CD in the
source component to be played.
@ Wait until the recording is completed.
@ Connect
them
properly
referring
to
"System connections'.
@ Adjust the volume to a proper level.
@ Press the MUTING key to OFF.
@vurn
the
power
off,
seliminate
the
short-circuiting,
then turn on the power
again.
@ Connect
it properly referring to "System
connections',
@ Adjust the Left/Right balance.
@ Connect
referring
to
them
properly
"System connections'.
@ Set the
Dolby Surround
or 3 STEREO
mode.
@ Adjust the REAR
LEVEL
and CENTER
LEVEL controls.
@Set
the
SPEAKER
IMPENDANCE
SELECTOR to the SURROUND ON side.
@ Insert the audio cord plugs securely into
the PHONO jacks.
@ Connect the grounding wire to the GND
terminal on the rear panel. .
Advertisement
Table of Contents
