Table of Contents
Advertisement
A\Caution : Read this page carefully to ensure safe
operation.
12. Carts and stands
—
An appliance and cart com-
ductors, location of antenna-discharge unit, connection
bination should be moved with care. Quick stops,
to grounding
electrodes,
and
requirements
for the
excessive force, and uneven surfaces may cause
grounding electrode. See Figure.
the appliance and cart combination to overturn.
®
EXAMPLE OF ANTENNA GROUNDING AS PER
NATIONAL ELECTRICAL CODE
ANTENNA
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)
ELECTRIC
SERVICE
*
ee
H
EQUIPMENT
13. Nonuse periods
The power cord of the unit
:
GROUNDING CONDUCT
should be unplugged from the outlet when left un-
(pag <= GROUND CLAMPS
used for a long period of time.
eat BOWER SERVICE GROUNDING
NEC — NATIONAL ELECTRICAL CODE
(NEC ART 250, PART H)
14. Abnormal smell
— _ |f an abnormal smell or smoke
is detected, immediately turn the power OFF and pull
18. Power lines — An outdoor antenna should be lo-
out the power cord. Contact your dealer or nearest
cated away from power lines.
service center.
.
;
POWER
OFF!
19. AC outlets — Donotconnect other audio equip-
|
ment with a power consumption larger than that
specified to the AC outlet on the rear panel. Never
connect other electrical units, such as an iron or
toaster, to it to prevent fire or electric shock.
15. Damage requiring service
—
The unit should be
serviced by qualified service personnel when:
A. The power-supply cord or the plug has been
damaged; or
B. Objects have fallen, or liquid has been spilled into
the unit; or
C. The unit has been exposed to rain; or
D. The unit does not appear to operate normally or
exhibits a marked change in performance; or
E. The unit has been droppéd, or the enclosure
damaged.
16. Servicing
—
The user should not attempt to ser-
vice the unit beyond that described in the operating
instructions. All other servicing should be referred
to qualified service pérsonnel.
17. Outdoor antenna grounding
—
If an outside an-
tenna is connected to the receiver, be sure the an-
tenna system is grounded so as to provide some
protection against voltage surges and built up stat-
ic charges. Section 810 of the National Electrical
Code, ANSI/NFPA 70, provides information with
respect to proper grounding of the mast and sup-
porting structure, grounding of the lead-in wire to
an antenna discharge unit, size of grounding con-
Notes:
a
1. Item 3 is not required except for grounded or polarized equipment.
2. Item 17 and 18 are not required except for units provided with antenna terminals.
3. Item 17 complies with UL in the U.S.A.
KR-V8040 (En) 5
Advertisement
Table of Contents
