Kenwood KR-V8040 Instruction Manual page 32

DSP / DSP LOGIC Presence
Tone control knobs
M@ Creating a DSP sound field
1 Select the presence mode.
Main unit or Remote control unit
DSP
pe — JAZZ CLUB
— DISCOTHEQUE « or
Each press switches over the
DSP LOGIC modes,
LARGE THEATER <> SMALL THEATER
3ch ¢ 4ch
@ Press the CENTER MODE key only in the DSP LOGIC
mode. : s . , 9 F :
Play the music source.
Now, a sufficient sound field effect of the pres-
ence mode can be obtained. However, you can
make additional adjustments as described in the
following.
e@ Even when the following presence parameters have
been adjusted, they will return to the initial settings
when the Dolby Surround mode or another presence
mode is selected.
3 Adjust the presence level.
i
PRESENCE LEVEL
PRESENCE
LEVEL + aS
Main unit Remote control unit
e@ Set in 2 dB steps within a range of — 20 to 0 dB.
32 KR-V8040 (En)
KENWOOD aunio-vago STEREO RECEIVER KR.va0U0
a Es ee ee
EELS P20 . ' ay 1 g petit v0 on
oa, yf en es Coit) Cir Chi CLL
- 7 = 7 + = *
DSP LOGIC key REAR LEVEL key
DSP key _ | CENTER LEVEL key
PRESENCE LEVEL key DELAY TIME key
4 Adjust the volume.
@) Adjust the center level.
@ Set within a range of - 40 to 0 dB.
REAR
LEVEL
Remote control unit
@ Adjust the rear level.
e Set within a range of - 40 to 0 dB.
CENTER REAR
LEVEL LEVE )
Remote control unit
e@ Perfrom step @ only when the DSP LOGIC mode is
set to "4 CH MODE".
6 Set the delay time.
ed)
Remote control unit
e@ The delay time can be adjusted in 1 ms steps within a
range of 1 ms to 50 ms.