Motorola MC31 Series Integrator Manual page 37

Button
Remove Button from Loop
Figure 1-24
Remove loop section from handle.
2.
Separate the loop and hook tape and pull the handstrap through the slot in the battery door.
3.
Remove Handstrap from Battery Door Slot
Figure 1-25
To install a new handstrap:
Insert one end of the loop section into the mounting slot in the handle.
1.
Thread the other end of the loop section through the loop and pull to tighten the loop.
2.
Thread Loop
Figure 1-26
Slip the button into the loop section.
3.
Loop
Getting Started 1 - 19