Salicru SPS ONE Series User Manual page 28

6. TROUBLESHOOTING GUIDE.
Use the following table to resolve minor issues:
Problem
Low battery.
No LED is lit on
Battery fault.
the front panel.
The UPS is not ON.
The alarm sounds
continuously The UPS is
when connected overloaded.
to the mains.
The UPS is
overloaded.
In the case of Battery voltage is
a problem in too low.
the mains, the
Defective battery. It
operating time is
may be due to the
very short.
ambient temperature
or inappropriate
operation.
There are no
problems in the The mains cable plug
mains but the is not connected
unit is in battery correctly.
mode.
Tabla 1. Troubleshooting table.
If you are registered on the website:
•
support.salicru.com
, you can access:
support.salicru.com/troubleshooting
, to consult the extended troubleshooting guide of the unit, in
addition to accessing other services available for registered
users.
28
Possible cause Solutions
Charge the UPS for at least 6
hours.
Replace the battery with the
same model.
Press the UPS start-up button
again.
First, disconnect a few loads.
Before starting it up again, check
that the connected load matches
the unit's power specifications.
Disconnect critical loads.
Charge the UPS for at least 6
hours.
Replace the battery with the
same model.
Reconnect the mains cable plug
correctly.
SALICRU