Precautions - Cognex VisionView Web Reference Manual

Precautions

To reduce the risk of injury or equipment damage, observe the following precautions when you install the Cognex product:
The VisionView Web requires a UL or NTRL listed power supply with a 24 VDC output.
l
Any other voltage creates a risk of fire or shock and can damage the components. Applicable national and local wiring
standards and rules must be followed.
This product is intended for industrial use in automated manufacturing or similar applications.
l
The safety of any system incorporating this product is the responsibility of the assembler of the system.
l
Do not install Cognex products where they are exposed to environmental hazards such as excessive heat, dust,
l
moisture, humidity, impact, vibration, corrosive substances, flammable substances, or static electricity.
Route cables and wires away from high-current wiring or high-voltage power sources to reduce the risk of damage or
l
malfunction from the following causes: over-voltage, line noise, electrostatic discharge (ESD), power surges, or other
irregularities in the power supply.
Do not expose the image sensor to laser light. Image sensors can be damaged by direct, or reflected, laser light. If
l
your application requires laser light that might strike the image sensor, use a lens filter at the corresponding laser
wavelength. For suggestions, contact your local integrator or application engineer.
This product does not contain user-serviceable parts. Do not make electrical or mechanical modifications to product
l
components. Unauthorized modifications can void your warranty.
Changes or modifications not expressly approved by the party responsible for regulatory compliance could void the
l
user's authority to operate the equipment.
Include service loops with cable connections.
l
Ensure that the cable bend radius begins at least six inches from the connector. Cable shielding can be degraded or
l
cables can be damaged or wear out faster if a service loop or bend radius is tighter than 10X the cable diameter.
This device should be used in accordance with the instructions in this manual.
l
All specifications are for reference purposes only and can change without notice.
l
3
Precautions