Kenmore 596.62822200 Use & Care Manual page 15

Hints and Care
How to
Remove and Replace Light Bulbs )/-_
•
e
1 WARNING ]
To avoid electrical shock which can cause severe personal injury or death,
disconnect power to refrigerator before replacing light bulb. After replacing light
bulb, connect power.
1 _ib CAUTION
To avoid personal injury or property damage, observe the following:
• Allow light bulb to cool.
• Wear gloves when replacing light bulb.
Refrigerator Section
1. Remove screw from light shield. Retain for E_
replacement.
1. Slide shield toward back of compartment to
release from light assembly.
2. Remove light bulbs.
3. Replace with appliance bulbs no greater than
40 watts.
4. Replace light bulb cover by inserting E_
tabs on light shield into liner holes on
each side of light assembly. Slide shield
toward front of unit until it locks into place.
DO NOT force shield beyond locking point.
Doing so may damage light shield.
5. Replace screw removed in step 1. ,_
(A) on light cover and pull straight _ /
I 2°RLove light bulb.
/
I 3. Replace bulb with appliance bulb no greater
I t_ )%LWi//
I than 40watts. |
I 4. Insert top tabs (B) of light cover into refrigerator _ _ |
liner and snap back portion over light assembly. ""------_ 1' _ _"
How to Get the
Most Out of
Your Energy
Dollar
When placing refrigerator into final
position, allow for 1" clearance
around the top and sides of unit to
supply ample ventilation for
optimmn energy efficiency.
tR
Z
Avoid overcrowding refrigerator
shelves. This reduces effectivity of
air circulation around food and
causes refrigerator to run longer.
Avoid adding too much warm 1%od
to unit at one time. This overloads
compartments and slows rate of
cooling.
Do not use aluminum foil, wax
paper, or paper toweling as shelf
liners. This decreases air flow and
causes unit to run less efficiently.
A freezer that is :/full in_ms most
efficiently.
Locate refrigerator in coolest part of
room. Avoid areas of direct sunlight,
or near heating ducts, registers, or
other heat producing appliances. If
this is not possible, isolate exterior
by using a section of cabinet or an
added layer of insulation.
Refer to ox_net s manual section on
temperature controls for
recommended control settings.
Clean door gaskets every three
months according to owner's
manual cleaning instructions. This
will assure that door seals properly
and unit runs efficientl3z
* Take time to organize items in
refrigerator to reduce time that door
is open.
Be sure your doors are closing
securely by leveling unit as
instructed in your owner's manual.
Clean condenser coils of as
indicated in the owner's manual
every 3 months. This will increase
energy efficiency and cooling
pert%nnance.
15