Table of Contents
Advertisement
2. TECHNICAL PROGRAMMING
2.1 Technical programming access "Automatic push-button strip"
_ _
1
2
3
To enter programming, press the
key for at least 3 seconds. The following message will
appear on the display:
TECHNICAL PROG.
CUP WARMER
KEY MENU
WATER
SELF.LEARNING
Copy unit
Display available menus: using the
the
key
Accessing the menus: position the cursor on the desired
line using the
and
keys, then press the
a selection key in the case of the "SELECT KEY" menu)
1
OK
OK
2
3
+
+
1
2
key twice and then the
+
and
keys, press
key (press
46 EN
(AUTOMATIC PUSH-BUTTON STRIP)
Changing menus and sub-menus: position the cursor on
the desired line using the
KEY MENU
type
dose .....
Select grinder
3
Change the selection or value, again using the
Note: when editing data, the cursor becomes "" or a slider
bar appears with the minimum and maximum values that
can be set:
water dose 064
0000
-
1
Exiting the programming panels: there are two options:
1) Confirm the changes by pressing the "OK" key
2) Exit the menu, leaving the data unchanged, by pressing
Enter TECHNICAL programming mode by pressing the
key; the message below will appear on the display
and then the following page by scrolling down.
TECHNICAL PROG.
CUP WARMER
KEY MENU
WATER
SELF LEARNING
Copy unit
TECHNICAL PROG.
CONFIGURATION
DATA MENU
MANUAL COMMANDS
Individual items are detailed below.
and
keys and then press
1 coffee
+
0100 imp
MM1-B
and
1999
+
2
+
+
+
+
keys
Hide quick links:
Advertisement
Table of Contents
