Advertisement
Operation
SETTING UP THE TRANSMITTER
NOTE: The remote has been pre-paired in the factory for your
convenience.
NOTE: Batteries will weaken with age and should be replaced
before leaking takes place as this will damage the remote
control. Dispose of used batteries properly and keep them out
of the reach of children.
Remove the battery cover by pressing rmly on the arrow and
sliding the cover off.
Install two 1.5V AAA batteries (CC) (included).
Replace the battery cover on the remote control (J).
LEARNING PROCESS
IMPORTANT: If you have two or more fans, please follow
steps below to control each fan independently. Also follow
steps below to re-pair the remote and the receiver when needed.
NOTE: The dip switch in the battery compartment has been
set on "0" position for your convenience. If you want to
re-pair the remote, please set the dip switch on "1" position.
To add a remote to your fan's memory, use the steps below:
Ensure AC power to the fan is OFF to begin the learning process.
Slide the dip switch in the battery compartment to the "1" position.
Turn the fan's AC power ON.
NOTE: If installing multiple fans on separate remotes, only
the fan being programmed should have AC power turned ON.
All other fans, even if they have already been programmed,
should have AC power OFF so they do not memorize other
remotes during the learning process. Separate the fan power
switches by approximately 2 meters.
Within 30 seconds of turning AC power on, press and release
the "LEARN" button located in the remote's battery compartment
to enter the learning function. The down light of your fan, if
applicable, will blink, and the fan blades will start to spin.
The fan will now accept commands from the added remote.
CC
If you would like to set the dip switch back to the "0" position
after a learning, please re-pair the remote by following the
learning process again.
J
13
Please contact 1-855-HD-HAMPTON for further assistance.
J
LEARN
1
+
0
LEARN
LEARN
1
+
0
HAMPTONBAY.COM
1
+
0
Advertisement
