Trane 2TEE3C31A1000A Installer's Manual page 7

Installer's Guide
SCREWS TO
REMOVE COIL
7/8"
Figure 10 DOWNFLOW BAFFLE KIT
DISCARD
TRAY
TRIANGULAR
BAFFLE
FRONT
SHIELD
SECT. X-X
(TYP. BOTH SIDES)
1/2" GASKET
INSIDE SURFACE
OF BAFFLE
SCREWS TO
REMOVE COIL
WATER _,
BLOW-OFF _ /_°_@,/ ,.,,,WATER_ _ kk°@° _
BAFFLES "_ /__', _--_ _o°o°o\,. _
ATTACH WITH "_"--/_o rLon/_) "_°o°°_,
2 SCREWS _'_ " "" /"_'_4
EACH SIDE I , -... ,/ ,-,.J,J
_LL WITH SEALANT
j.
If a return duct is connected to the Air Handler,
it must be the same dimensions as the return
opening shown in the outline drawings on page
18.
k. Openings where field wiring enters the
cabinet must be completely sealed. Location
of power entry is shown on the Outline Drawing.
Use 2.5" clear stickers to seal all unused electri-
cal knockouts. See Figure 9.
1. After ductwork connections are made, seal air-
tight and per Local codes.
HORIZONTAL RIGHT
a. For maximum efficiency and Customer ease of
flter maintenance, it is recommended that a
properly sized remote filter grille be installed
for horizontal applications. Airflow should not ex-
ceed the face velocity of the filter being used.
The factory installed filter should then be
removed from the unit.
For Maximum Efficiency
on Horizontal Left_
_flow and Downflow
Remove Replace
and with
Discard Narrow
Baffle
Figure 11
b. Unit is shipped from the factory in the upflow or
horizontal right configuration. Unit conversion is
not required.
18-GE11 D1-4 7