Product And Component Identification; Machine; Engine - jcb 457 Operator's Manual

Product and Component Identification

Machine

Your machine has an identification plate. The PIN (Product Identification Number), weight, engine power, year
of manufacture and serial number of the machine are shown on the identification plate.
The serial number of each major unit is also shown on the unit itself. If a major unit is replaced by a new one,
the serial number on the identification plate will be wrong. Either get a replacement identification plate from
your JCB dealer or simply remove the old number. This will prevent the wrong unit number being quoted when
replacement parts are ordered.
A Identification plate (location)
The machine model and build specification are indicated by the PIN. The PIN has 17 digits and must be read
from left to right.
JCB
Digit Description
1 to 3 World manufacturer identification. For example, JCB = UK Build.
4 to 6 Machine type and model
7 O = HT Loader End, Z = ZX Loader End
8 Designation: O = Non-Farmmaster, S = Farmmaster, I = India
9 Year of manufacture: 7 = 2007, 8 = 2008, 9 = 2009, A = 2010, B = 2011, C = 2012
10 to 17 Machine serial number

Engine

The engine data plate is attached to the rear face of the crankcase below the alternator as shown.
The data label includes the engine identification number.
8
Figure 4.
Table 1. Typical PIN
457 Z
Table 2. Explanation of the PIN
9821/3700-4
Product and Component Identification
A
S D
About the Product
02244514
8