Table of Contents
Advertisement
3. Operating the Appliance
•
When operating this appliance, please take care to ensure that all parts are in good working order
and that you have checked for any gas leaks before lighting the appliance with every use.
•
Items can simply be placed on top of each other.
•
PLEASE NOTE: Please ensure all protective packaging and plastic are removed from the appliance
before use.
Precautions to observe before lighting.
•
Use this appliance only on a firm level surface.
•
After prolonged storage, inspect the appliance for any insects and webs, which may affect gas
flow.
Lighting the appliance using the piezo
•
It is recommended to remove any cooking surfaces when trying to light the appliance. This way it
will be easy to see the burner when it is lit.
•
To light up the appliance using the piezo igniter, push and turn the control knob 90° in an anti-
clockwise direction, then press the piezo button to ignite the gas (see Fig. 4). If the gas does not
ignite on the first spark, turn the control knob back to its "OFF" position. Try again, by pushing
and turning the control knob anti-clockwise and push the piezo button to ignite the gas. If the gas has not ignited in the first two to three
seconds you should close the control valve by turing the control knob back to its "OFF" position.
•
Wait approximately thirty seconds to let any accumulated gas within the burner escape. Repeat the above process if necessary until the
flame ignites. The flame should normally light up within the first one to two seconds.
Lighting up using a BBQ lighter
•
When starting cold, the appliance may be lit from the top prior to fitting the desired cooking surface. When lighting up a hot appliance, it
is recommended that this be done by sticking a barbecue lighter through one of the vent holes underneath the burner, until it is in line with
the burner (DO NOT place the BBQ lighter through the large hole directly underneath the burner). Ignite the BBQ lighter. Whilst the BBQ
lighter is lit, push and turn the control knob anti-clockwise to light the burner.
General
•
Once the appliance is lit, the flame intensity may be adjusted by turning the control knob anti-clockwise to reduce the flame or clockwise to
increase the flame.
•
When cooking food with a high fat content, flaring may occur if the selected heat setting is too high. Should this happen, turn the heat down
until the flaring ceases.
•
Do not move the appliance when in use. It is unsafe practice to move the appliance whilst lit and may cause flaring.
•
After use, first close the control valve on the gas cylinder (where applicable). When the flame has extinguished, close the control valve on
the appliance.
4. Component List
Product code: 203P1-20
3 3
Piezo
button
Flat Grill Plate
(used for frying)
Ribbed Grill Plate
(used for Grilling)
Grill Handle
Coffee Pot Stand
(used for Coffee making)
Pot Stand
(used for Boiling)
Lid
Wind Shield
Burner
Control Knob
Piezo Button
EN
Fig. 4
Advertisement
Table of Contents
