Page 1
Operating and Installation Instructions CRAMER COE Gas Cooker Models: COE-C Cooker (4 gas burners) COE-CG Cooker + grill (4 gas burners) COE-CGO Cooker + grill + oven (4 gas burners) COE-FULL Cooker + grill + oven + pot store (4 gas burners)
Page 2
Important This appliance is a class 3 appliance intended for installation in a kitchen unit. Output of the hob (Hs) 4 x 1.6 = 6.4 kW (Mn = 465 g/h, propane/butane) or, in the case of the DUFU (dual fuel) model: Output of the hob (Hs) 3 x 1.6 = 4.8 kW (Mn = 465 g/h, propane/butane)
The operator is responsible for having the necessary inspections conducted. S/he must be notified in writing of the inspection requirement by the technician who installs the appliance. The appliance may be used only for cooking, baking and grilling under the conditions specified elsewhere in these instructions.
The following applicable regulations must be observed when installing the gas appliance EN 1645-1 EN 1646-1 EN 1648 EN 1949 EN 60335 EN 721 (In Germany, the 1988 Technical Rules Governing Liquid Gas, and the rules specified in the DVGW worksheets G 607 (vehicles) and/or G 608 (boats) must also be observed).
Page 5
CAUTION! The following safety precautions must be taken when replacing the gas cylinder: a) Close the gas taps (turn rotary knob to 0 position). b) Close the shut-off valve for the appliance in the vehicle. c) Make sure that there are no naked flames or glowing embers nearby. d) Close the valve of the gas cylinder to be replaced.
section of each cable must be at least 1.0 mm . All three poles are marked with the appropriate symbols on the terminal. THE ELECTRIC SYSTEM (IN THE CASE OF THE COE … DUFU MODELS) MUST INSTALLED AUTHORISED TECHNICIAN ACCORDANCE WITH THE APPLICABLE REGULATIONS. NEVER CONNECT THE 12 V DC CONNECTION TERMINAL TO THE 230 V AC MAINS NETWORK.
Page 7
7. FITTING THE APPLIANCE 7.1 MOUNTING THE APPLIANCE For the installation of the appliance, there must be a free space as indicated in Fig. 1, depending on the individual model (see type plate on appliance). Fig. 1 The installation location is limited only as follows: The appliance must rest on a firm and stable base with mounted in the cabinet.
Page 8
Fig. 2 The following minimum distances shown in the sketch must always be observed when installing the appliance. a: The minimum distance (a) between the burner edge and side moveable walls made of flammable materials is 200 mm. If a flame guard is used, the distance between it and the side moveable wall must be at least 3 mm.
7.2 REMOVING THE APPLIANCE FROM THE CABINET a) Close the gas taps on the appliance b) Close the shut-off valve. c) Close the valve of the gas cylinder to be replaced. d) Remove fastening screws e) Disconnect the gas supply and any electric cables 8.
Caring and cleaning for your appliance 9.2.1 CLEANING INSTRUCTIONS Only clean your appliance using a mild household cleaner. 9.2.2 Allow the appliance to cool down before cleaning it. 9.2.3 To avoid damaging the appliance, clean the exterior surfaces using a damp cloth without the addition of chemical or granular cleaning agents.
CAUTION: The appliance will become very hot when in use. Keep children away! 10. APPLIANCE FAULTS Consult a specialist technician in the event of appliance faults. DOMETIC CRAMER SR s. r. o. Tehelná 8 SK – 986 01 Fiľakovo Telephone: +421-47 4319100 ●...