Step 1 Hardware Preparation - Ebyte E18 Series Operation Instructions Manual

Zigbee wireless module

Hide thumbs Also See for E18 Series:

Chengdu Ebyte Electronic Technology Co,;Ltd

Step 1 Hardware preparation

Prepare the following items：

 Debugger/Programmer CC Debugger

 Ebyte E18 seires module or E18 series test kits

Step 2 Install tools and drivers

To obtain the USB drivers required by the tools, it is recommended to download and install the tools listed below:

SmartRF™ Flash Programmer



After the tool is installed, the driver will be stored in the following default path:

C:\Program Files\Texas Instruments\SmartRF Tools\Drivers\cebal

Step 3 Connect debugger/programmer to target module/test kit

Connect debugger/programmer to target module/test kit，The minimum connections required for SOC debugging and

programming are shown in the below:

For the pin definitions of E18 series modules/test kits, please refer to the relevant product manuals.

Chengdu Ebyte Electronic Technology Co,;Ltd

https://www.ti.com/tool/FLASH-PROGRAMMER

CC Debugger

GND

Target Voltage Sense

DC(Debug Clock)

DD(Debug Data)

RESETn

https://www.ebyte.com/en/product-view-news.html?id=947

https://www.cdebyte.com/product_serch/E18-/1/

connecting

E18 modules/test kit

GND

RESET

VCC

P2.2

P2.1

AN2022001

Table of Contents