For Your Safety - Fein KBE 36 MAGSPEED Manual

en
30
Character
HM
Fe 400
HSS
Fe 400
HSS
Fe 400
T
a
L
pA
L
wA
L
pCpeak
K...
h

For your safety.

Read all safety warnings and all
WARNING
instructions. Failure to follow the
warnings and instructions may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future reference.
Do not use this power tool before you have
thoroughly read and completely understood this
Instruction Manual and the enclosed "General
Safety Instructions" (document number
3 41 30 465 06 0). The documents mentioned should
be kept for later use and enclosed with the power tool,
should it be passed on or sold.
Please also observe the relevant national industrial
safety regulations.
Intended use of the power tool:
Magnetic core drill unit for drilling with core drill bits
and solid drill bits on materials with surfaces suitable for
magnets in weather-protected environments using the
application tools and accessories recommended by
FEIN.
In environments subject to interference, a reduction of
the operating quality is possible; this can include tem-
porary failure, temporary reduction of the function or
the intended operating behaviour, for the correction of
which intervention by the operator is required.
This product is also suitable for use with AC generators
with sufficient power output that correspond to the
Standard ISO 8528, design type G2. This Standard is
particularly not complied with when the so-called dis-
tortion factor exceeds 10%. When in doubt, please
refer to the generator instruction / specification guide.
Observe the operating instructions and the national
regulations for the installation and operation of the AC
generator.
Unit of measurement,
international
mm
mm
mm
kg
°C
dB
dB
dB
2
m/s
2
m/s
m, s, kg, A, mm, V, W,
Hz, N, °C, dB, min, m/s
Explanation
Max. capacity in steel with up to 400 N/mm
TCT (core drill bit)
Max. capacity in steel with up to 400 N/mm
high speed steel (core drill bit)
Max. capacity in steel with up to 400 N/mm
high speed steel (twist drill bit)
Weight according to EPTA-Procedure 01
Allowable ambient temperature
Sound pressure level
Sound power level
Peak sound pressure level
Uncertainty
Vibrational emission value according to EN 62841
(vector sum of three directions)
Mean vibrational value for core drilling
Basic and derived units of measurement from the
2
international system of units SI.
WARNING
exceeds the voltage value on the type plate of the
power tool is prohibited.
All other types of use are considered as not intended
for.
Safety instructions.
When performing drilling that requires the use of a
fluid, route the fluid away from the operator's work
area or use a fluid collection device. Such precaution-
ary measures keep the operator's work area dry and
reduce the risk of electrical shock.
Operate the power tool by the insulated gripping sur-
faces when performing operations where the cutting
accessory could contact hidden wiring or its own power
supply cable. Contact of a cutting accessory with a
"live" wire may make exposed metal parts of the power
tool "live" and could give the operator an electric
shock.
Wear hearing protection when drilling. Exposure to
noise can cause hearing loss.
When the core bit is jammed, stop applying downward
pressure and turn off the tool. Check the cause of the
jam and apply corrective action to eliminate the cause
of the jamming application tool.
When restarting a core drill jammed in the workpiece,
check that the core bit rotates freely before starting. If
the core bit is jammed, it may not start, may overload
the power tool, or may cause the core drill to release
from the workpiece.
Operating the power tool off power
generators whose no-load speed
2
–
2
–
2
–