For Your Safety - Fein WPO 13-15 E Instruction Manual

3 41 01 061 06 0.book Seite 13 Mittwoch, 12. Juli 2006 8:02 08
WPO 13-15 E / WPO 13-15 IE
Symbol Term, meaning
CAUTION
It is forbidden to dispose of
the product in the unsorted
household waste.
Protective class II
mm Millimeter
kg Kilogram
V Volt
A Ampere
Hz Cycles per second
W Watt
min Minutes
~ or a. c. Current type
or d. c. Current type
1 ~ Power supply type
n No-load speed
o
1/min per minute
Ø Diameter

For your safety.

Do not use this power tool before you
have thoroughly read and completely
understood this Instruction Manual and the
enclosed "General Safety Instructions" (docu-
ment number 3 41 30 054 06 1), including the
figures, specifications, safety regulations and the
signs indicating DANGER, WARNING and
CAUTION.
Please also observe the relevant national indus-
trial safety regulations (e. g. in Germany:
BGV A3, BGR 500).
Non-observance of the safety instructions in the
said documentation can lead to an electric shock,
burns and/or severe injuries.
This Instruction Manual and the enclosed "Gen-
eral Safety Instructions" should be kept for later
use and enclosed with the power tool, should it
be passed on or sold.
Explanation
This sign warns of a possible dangerous situation
that could cause injury.
Worn out power tools and other electrotechnical
and electrical products should be sorted sepa-
rately for environment-friendly recycling.
Product with double or reinforced insulation
Unit of measure for length, width, height or depth
Unit of measure for the mass
Unit of measure for the electric voltage
Unit of measure for the electric current intensity
Unit of measure for the frequency
Unit of measure for the output
Unit of measure for the time
Alternating current
Direct current
Alternating current single-phase
Revolution speed at no-load
Unit of measure for number of revolutions,
strokes, impacts or oscillations per minute
Diameter of a round part
Special safety instructions.
Operations such as rough grinding or cut-off
grinding are not recommended to be performed
with this power tool. Operations for which the
power tool was not designed may create a haz-
ard and cause personal injury.
Do not rivet or screw any name-plates or signs
onto the power tool. If the insulation is damaged,
protection against an electric shock will be inef-
fective. Adhesive labels are recommended.
Wear personal protective equipment. Depending
on the application, use face shield, safety goggles
or safety glasses. As appropriate, wear dust mask,
hearing protection, gloves and shop apron capable
of protecting you against flying debris from the
accessory or workpiece. The eye protection
must be capable of protecting against flying par-
ticles generated by the various different opera-
tions. The dust mask or respirator must be
capable of filtering particles generated by your
operation. Prolonged exposure to high-intensity
noise may cause loss of hearing.
EN
13