Positioning - Smeg A2-81 Manual

2. Gently rotate the plate and remove it
from its seat.
3. Proceed with installation of the power
supply cable.
It is recommended to slacken off
the cable clamp screw before
installing the power supply cable.
4. When you have finished, reposition the
plate on the rear casing and fasten it in
place with the previously removed
screws.
96
Installation

5.4 Positioning

• Position the appliance into the cabinet
cutout with the help of a second person.
• Never use the oven door to lever the
appliance into place when fitting.
• Avoid exerting too much pressure on the
oven door when open.
• Veneers, adhesives or plastic coatings
on adjacent furniture should be
temperature-resistant (no less than
90°C).
General information
This appliance may be installed next to
walls, one of which must be higher than the
worktop, at a minimum distance of 150 mm
from the side of the appliance, as shown in
figures A and C relative to the installation
classes.
Heavy appliance
Danger of crushing injuries
Pressure on the open door
Risk of damages to the appliance
Heat production during appliance
operation
Risk of fire