Fujitsu ASBG09KMBA Design & Technical Manual page 29

2) Filter sign
Select appropriate intervals for displaying the filter sign on the indoor unit according to the estimated
amount of dust in the air of the room.
If the indication is not required, select "No indication" (03).
Function number
11
3) Room temperature sensor control for cooling
Depending on the installed environment, correction of the room temperature sensor may be re-
quired. Select the appropriate control setting according to the installed environment.
Function number
30
4) Room temperature sensor control for heating
Depending on the installed environment, correction of the room temperature sensor may be re-
quired. Select the appropriate control setting according to the installed environment.
Function number
31
5) Auto restart
Enables or disables automatic restart after a power interruption.
Function number
40
NOTE: Auto restart is an emergency function such as for power outage etc. Do not attempt to use
this function in normal operation. Be sure to operate the unit by remote controller or exter-
nal device.
6) Room temperature sensor switching
(Only for wired remote controller)
When using the wired remote controller temperature sensor, change the setting to "Both" (01).
Function number
42
00: Sensor on the indoor unit is active.
01: Sensors on both indoor unit and wired remote controller are active.
NOTE: Remote controller sensor must be turned on by using the remote controller.
11-1. Function settings by using remote controller
Setting value
00
01
02
03
Setting value
00
01
02
03
Setting value
00
01
02
03
Setting value
00
01
Setting value
00
01
- 25 -
Setting description
Standard (400 hours)
Long interval (1,000 hours)
Short interval (200 hours)
No indication
Setting description
Standard
Slightly lower control
Lower control
Higher control
Setting description
Standard
Lower control
Slightly higher control
Higher control
Setting description
Enable
Disable
Setting description
Indoor unit
Both
Factory setting
♦
Factory setting
♦
Factory setting
♦
Factory setting
♦
Factory setting
♦
11. Function settings