Advertisement
Quick Links
Advertisement
Related Manuals for LAVAZZA Bunn Nitron
Summary of Contents for LAVAZZA Bunn Nitron
- Page 1 Bunn Nitron Lavazza Ambient Cold Brew 7:1 Changes...
- Page 2 Lavazza is changing the cold brew formula from the existing 5 to 1 refrigerated concentrate to a 7 to 1 ambient concentrate. This ratio change requires adjustments to the Bunn Nitron Cold Brew machine. Please follow the instructions below to make these changes. If you have any issues or technical questions, please call 1-888-952-8299.
- Page 3 3. Remove the drip tray and remove the two straight blade screws (circled in yellow in the picture below). Once the screws are removed, pull out and down on the cover exposing the circuit board. 4. Place the machine in programming mode using the switch in the bottom middle as shown in the picture below.
- Page 4 (From the factory, the water regulator located behind the right-side panel is set to this measurement. In most cases, unless this was tampered with, step 7 should not be needed) If your volume was low or high, remove the 4 screws in the corners of the right-side panel and remove the panel.
- Page 5 Turning the screw in (clockwise) will decrease volume. Turning the screw out (counterclockwise) will increase volume. Try to achieve a volume as close as possible to 133mL or 4 ½. It is ok to have a volume on the cold brew (right side) between 127 mL to 139 mL, as the product chart in step 11 allows for some variation.
- Page 6 Re-plug in the nitrogen generator and taste the product to ensure that it is correct. 13. Replace the front cover, re-install the two screws, and replace the drip tray. The Bunn Nitron is now ready for use with the 7 to 1 product.