LAVAZZA FLAVIA C600 Cleaning Procedures
LAVAZZA FLAVIA C600 Cleaning Procedures

LAVAZZA FLAVIA C600 Cleaning Procedures

Advertisement

Quick Links

Daily Care:

EMPTYING AND CLEANING THE DRIP TRAY

The drip tray is a 3-piece design with the lower part used to collect spillages or overflows. If the drip
tray is full, spillages will leak from the highlighted area in the next section. To avoid overflow, please
check the drip tray regularly.
1.
Lift out and empty drip tray. CAUTION - CONTENTS MAY BE HOT.
2.
Lift out the cup stand.
3.
Separate the remaining top and bottom parts of the tray.
4.
Hand wash the drip tray top, and cup stand rings.
5.
Wash the remaining parts in the dishwasher. Alternatively, clean them in warm, soapy water. Wipe
the area underneath and around the drip tray.
6.
Reassemble the top and bottom halves of the drip tray. Drop in the adjustable cup stand ensuring it
is in its lowest position. Do not force it flat. If the stand is raised, please see the instructions below
as to how the lowest cup stand position is reset.
7.
Once reassembled, drop the drip tray back into the base of the brewer and push it gently towards
the brewer. Magnets will help lock It in place. The cup stand will automatically be lifted up and
down. The brewer will then be ready to vend drinks again.
FLAVIA C600 Cleaning Procedures
LAVAZZA PROFESSIONAL
1301 Wilson Drive
West Chester, PA 19380 U.S.A.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FLAVIA C600 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for LAVAZZA FLAVIA C600

  • Page 1 FLAVIA C600 Cleaning Procedures Daily Care: EMPTYING AND CLEANING THE DRIP TRAY The drip tray is a 3-piece design with the lower part used to collect spillages or overflows. If the drip tray is full, spillages will leak from the highlighted area in the next section. To avoid overflow, please check the drip tray regularly.
  • Page 2 RE-ASSEMBLING THE CUP STAND In order to prevent permanent damage to the cup stand when dropped, it has been designed to come apart and can be re-assembled by following the below steps: LAVAZZA PROFESSIONAL 1301 Wilson Drive West Chester, PA 19380 U.S.A.
  • Page 3 Remove Freshpack door to access air duct. Clean cup sensors and air ducts. After cleaning, sanitize surfaces with a non- chlorine based anti-bacterial wipe or solution. Avoid scented products, as they will affect drink taste. LAVAZZA PROFESSIONAL 1301 Wilson Drive West Chester, PA 19380 U.S.A.
  • Page 4 Push the door to fully close it and replace the Freshpack bin and drip tray if they were removed in step 1 as the brewer was out of power. Dispense 1 cup of hot water through the system to provide a final rinse and discard. LAVAZZA PROFESSIONAL 1301 Wilson Drive West Chester, PA 19380 U.S.A.
  • Page 5 If you have any questions or issues while performing these procedures, please contact FLAVIA Technical Support at 1-877-273-5812 Option 2 or by emailing US.TechSupportNA@LavazzaPro.com LAVAZZA PROFESSIONAL 1301 Wilson Drive West Chester, PA 19380 U.S.A.

Table of Contents