Important Note - Lifemax BRD2180 Owner's Manual & Assembly Instructions

A s s e m b l y S t e p 3
Remove Hex Bolts (#05) and Nylon Nuts (#45) that are pre-assembled on the Pedal Connection Joint (#66A) and set
them aside as they will be used in a later process.
Attach the Pedal Connection Joint (#66A) to the Right Pedal Tube (#06R). Insert a Hex Bolt (#05) through the upper
bracket of the Pedal Connection Joint (#66A), followed by Right Pedal Tube (#06R) then the lower bracket of the Pedal
Connection Joint (#66A). Secure them with a Nylon Nut (#45).
Attach three Caps (#42) on three Hex Bolts (#05) as illustrated in the drawing below.
Align and attach the Pedal Connection Joint (#66A) on the Right Pedal Tube (#06R) to the right Crankshaft (#27). Insert
the Right Pedal Hinge Bolt (#62) through one Wavy Washer (#86), followed by Pedal Connection Joint (#66A) and
Crankshaft (#27) . Secure the Right Pedal Hinge Bolt (#62) tightly into the Crankshaft (#27) by turning CLOCKWISE.
Next, insert one Lock Pin for Pedal Hinge Bolt (#54) into the small hole located at the end of the Right Pedal Hinge Bolt
(#62). Fit the Wavy Washer (#64) over the Lock Pin for Pedal Hinge Bolt (#54) and the Right Pedal Hinge Bolt (#62)
then, secure with a Spring Washer (#51) and a Right Nylon Nut [with WHITE inner nylon ring] (#49) .
PLEASE NOTE: a):Turn Right Pedal Hinge Bolt (# 62) CLOCKWISE and the
Right Nylon Nut [with WHITE inner nylon ring] (# 49) COUNTERCLOCKWISE to tighten.
Repeat the above process on the left side of the machine but turn the Left Pedal Hinge Bolt (# 63) COUNTER-CLOCKWISE.
PLEASE NOTE: a):Turn Left Pedal Hinge Bolt (# 63) COUNTERCLOCKWISE and the
Left Nylon Nut [with BLACK inner nylon ring] (# 48) CLOCKWISE to tighten.
RIGHT Side
NA95N
Assembly Instructions
86
Left Crankshaft
48 48
63 86

IMPORTANT Note:

Keep the Right/Left Pedal Hinge Bolt (#62/63) and the
Wavy Washer (#86) perfectly straight as they go through the
Pedal Connection Joint (#66A) and the Crankshaft (#27).
If the Right/ Left Pedal Hinge Bolt (#62/63) are connected to
the Crankshaft (#27) incorrectly, or, the Wavy Washer
(#64) does not fit the Lock Pin for Pedal Hinge Bolt (#54)
tightly, damage to the Right/ Left Pedal Hinge Bolt (#62/63)
and Crankshaft (#27) will occur.
Right Crankshaft
86
Page 8