Lifemax BRD2180 Owner's Manual & Assembly Instructions page 15

A s s e m b l y S t e p 8
Connect the pin on the tip of the Sensor Wire (#26b) to the corresponding socket of the wire end on the Electronic
Monitor (#50) as shown in diagram below. Attach the Electronic Monitor (#50) by sliding it in place onto the tip of the
Center Post (#77).
ASSEMBLY IS NOW COMPLETE. HOWEVER, PLEASE READ ALL SAFETY GUIDELINES &
WARNING LABELS BEFORE USING THE UNIT TO AVOID SERIOUS INJURY.
#42 WASHER FOR M10 BOLT,T2.0 1PC
#42 WASHER FOR M10 BOLT,T2.0 1PC
NA95N
Assembly Instructions
#42 WASHER FOR M10 BOLT,T2.0 1PC
Page 14