Table of Contents
Advertisement
A s s e m b l y S t e p 2
Remove the Nylon Nuts (#45) and Washers (#56) that
are pre-assembled on the Handlebar Axle (#12) and set
them aside as they will be used later in this step.
Insert the Handlebar Axle (#12) through the main frame.
Make sure the Handlebar Axle (#12) is centered. If you
encounter too much friction, try using WD40 or Vaseline as
a lubricant.
Please refer to the "Note:" and image below and properly
attach Left Coupler Bar (#04L) and Right Coupler Bar (#04R)
to the main frame via the Handlebar Axle (#12).
Again, use WD40 or Vaseline to reduce friction if needed.
Once the Left Coupler Bar (#04L) and Right Coupler
Bar (#04R) are correctly situated, fasten the end of the
Handlebar Axle (#12) with a Washer (#56) and a Nylon
Nut (#45) on each side. Then cap each end with a Cap (#42).
Note:
Make sure Left /Right Coupler Bar (04L/04R) are placed on the correct side when its horizontal Pivot Tube (which is
welded at the top) faces the REAR of the machine as seen from the user .
NA95N
Assembly Instructions
101
Hardware & Tool Required
Washer
#56 Washer (φ10.2xφ25x2) [2 Pieces]
#45 Nylon Nut (M10) [2 Pieces]
Others
STEP3:
#12 Handlebar Axle (φ16x410 mm) [1 Piece]
#42 Cap (S17) [2 Pieces]
Tools
#68 Tool 1 (2-S17,S19) [2 Pieces]
55
40
1
2
3
4
Page 7
Advertisement
Table of Contents
