Lifemax BRD2180 Owner's Manual & Assembly Instructions page 12

A s s e m b l y S t e p 5
Remove Washers (#81) and Nylon Nuts (#82) that are
pre-assembled on the back of the Seat (#79) and set them
aside as they will be used later in this step.
Attach the Seat (#79) to the Horizontal Seat Bar (#80)
using a total of three Washers (#81) and three Nylon Nuts
(#82).
Remove the Knob Bolt (#57) that is pre-assembled on the
Main Frame (#101) and set it aside for now, as it will be used
later in this step.
Insert the Horizontal Seat Bar (#80) into the Seat Post
(#83). Insert a Knob Bolt (#17) through a Washer (#84),
followed by the Seat Post (#83) and Horizontal Seat
Bar (#80), secure them together by tightening the Knob
Bolt (#17) up through the bottom of the Horizontal Seat Bar
(#80).
#42 WASHER FOR M10 BOLT,T2.0 1PC
Insert the Seat Post (#83) a minimum of 4 inches into the
Main Frame (#101) to engage the lowest hole and secure by
screwing in the Knob Bolt (#57). Please ensure that the hole
on the Seat Post (#83) is facing the same side as the Knob
Bolt (#57) so it can be aligned and fully engage through the
lowest corresponding hole on the Main Frame (#101).
#42 WASHER FOR M10 BOLT,T2.0 1PC
You may adjust the Seat Post (#83)
to the height most comfortable for you
after complete assembly. Please always
check to ensure a hole has been fully
engaged when you secure and tighten
the Knob Bolt (#57).
NA95N
Assembly Instructions
#42 WASHER FOR M10 BOLT,T2.0 1PC
Hardware & Tool Required
Washer
#81 Washer (φ8.2x1.2xφ17)
[3 Pieces]
Nut
#82 Nylon Nut (M8)
[3 Pieces]
Others
#17 Knob Bolt (M8x36 mm)
[1 Piece]
Tools
#70 ool 3 (S13-14-15)
#84 Washer (φ10.5x2xφ20)
[1 Piece]
#57 Knob Bolt (M 12 x24 mm)
[1 Piece]
Page 11