Advertisement
Quick Links
Description
Acceleration Sensor
Accelerometer Type
Acceleration Range
Acceleration Resolution
Calibrated Accuracy
Memory
Reading Rate
Frequency Response
0Hz to approximately 400Hz (50, 100 g)
Typical Battery Life
Required Interface Package
Baud Rate
Operating Environment
–20 °C to +60 °C, 0 to 95%RH (non-condensing)
Dimensions
3.5" x 4.4" x 1.0" (89 mm x 112 mm x 26 mm)
Materials
Weight
Approvals
*TSR101 Acceleration Range, Resolution and Accuracy
Range (g)
+5
Resolution (g)
0.01
Accuracy (g)
+0.2
Battery Warning
WARNING: FIRE, EXPLOSION, AND SEVERE BURN HAZARD. DO NOT SHORT CIRCUIT, CHARGE,
FORCE OVER DISCHARGE, DISASSEMBLE, CRUSH, PENETRATE OR INCINERATE. BATTERY MAY
LEAK OR EXPLODE IF HEATED ABOVE 60 °C (140 °F).
Find Quality Products Online at:
TSR101
Shock (3 axes)
MEMS Semiconductor
*See Table for Details
349,471/channel
1,024Hz to 1 second
7 days
IFC200
115,200
Anodized aluminum
12 oz (340 g)
CE
+50
+100
+250
0.05
0.1
0.2
+1
+2
+4
DOC-1161035-00 REV 11 01.23.2018
GlobalTestSupply
www.
Product Information Card
TSR101-5
Tri-Axial +5g, Transient Shock Data Logger
TSR101-50
Tri-Axial +50g, Transient Shock Data Logger
TSR101-100
Tri-Axial +100g, Transient Shock Data Logger
TSR101-250
Tri-Axial +250g, Transient Shock Data Logger
.com
sales@GlobalTestSupply.com
TSR101
Red 485
Dark Blue Pantone 289
Light Blue 58% of Pantone 289
Advertisement
Related Manuals for MadgeTech TSR101-5
Summary of Contents for MadgeTech TSR101-5
- Page 1 +100 +250 Resolution (g) 0.01 0.05 Accuracy (g) +0.2 TSR101-5 Tri-Axial +5g, Transient Shock Data Logger TSR101-50 Battery Warning Tri-Axial +50g, Transient Shock Data Logger WARNING: FIRE, EXPLOSION, AND SEVERE BURN HAZARD. DO NOT SHORT CIRCUIT, CHARGE, TSR101-100 FORCE OVER DISCHARGE, DISASSEMBLE, CRUSH, PENETRATE OR INCINERATE. BATTERY MAY Tri-Axial +100g, Transient Shock Data Logger LEAK OR EXPLODE IF HEATED ABOVE 60 °C (140 °F).
- Page 2 TSR101 Product Information Card Device Operation Product Notes Connecting and Starting the data logger How it Works Once the logger is started samples are taken on each axis (X, Y and Z) every 1024Hz - Once the software is installed and running, plug the interface cable into the data logger. - Connect the USB end of the interface cable into an open USB port on the computer.