Selecting The Channel - Radioddity FS-T7 FRS US User Manual

Selecting the Channel

The channel is the frequency of the radio uses to transmit. Your radio has 16 channels and 155 Sub-Codes you can
use to talk to others. In order to speak to someone, both your radios must be set to the same channel and Privacy
code.
1) Press and hold the [ /CALL] button until the radio is turned on.
2) Press [ /MENU] button until the channel number starts to flash.
3) Press [ ] or [ ] to change the channel. Long press on these keys allows you to scroll through the channels
rapidly to browse the codes.
4) Press [PTT] button to exit menu or [ /MENU] button to continue set up.
If the [ /MENU] button is locked, please press and hold the [ /MENU] button for 3 seconds to unlock.
CTCSS/DCS tones selection
FS-T7 can receive in two modes:
• Open traffic: in this case you will hear any communication transmitted on the selected channel;
• Group mode CTCSS/DCS: CTCSS/DCS tones are access keys that allow you to receive only messages coming from
parties using the same channel and code. The speaker will remain muted until the correct tone is received.
To activate 1 of 50 different CTCSS/105 DCS tones in RX and TX
1) To select CTCSS/DCS, press [ /MENU] twice until the display shows CTC or DCS (flashing on the lower left).
2) By pushing the [ ] or [ ] button the display will show CTCSS (ct blinking) or DCS (dc blinking); press [ /MENU]
to enter the CTCSS or DCS tones. Now select the desired tone with the [
3) Press the [PTT] button to exit menu or [ /MENU] button to continue set up.
] or [ ] buttons.
9