Table of Contents
Advertisement
10. Fit C-cover – Follow steps 2-4 of the C-cover reassembly instructions. Do not install any Feet screws.
11. Check AB-cover alignment – Close the device and confirm flushness of feeler gauge to display module
cover across the rear corners of each hinge.
a.
If flush, move to next step in this section.
b. If not flush, follow steps for removing AB-hinge screws and steps for 9a thru 9c again until flush. Then
follow steps for C-cover reassembly.
12. rSSD Install – Follow steps for Procedure – Installation (rSSD) section
13. C-cover Install – Follow steps for Procedure – Installation (C-cover Keyboard metal type) section
14. Run SDT – Power on device. Validate full device functionality by running SDT tool.
a.
If an SDT failure occurs, assess failure to determine if caused by any improper or missed step in the repair
process and correct.
b. Any failure that is not correctable should result in device exchange.
15. Install Feet – If SDT tests pass and no further actions are to be performed on the device, follow steps for
Procedure – Installation (Non-Skid Feet) section
49
(page
(page
20).
M1179886
37).
(page
27).
Advertisement
Table of Contents
