Table of Contents
Advertisement
e.
Power on device – Depress the power button on the C-cover to power on the device.
Run software tool – At the device OS, use Windows Explorer, navigate to USB drive and run:
f.
STEP2_DisplayModuleReplacement.cmd. Follow prompts, device will restart. Verify touch by running
finger across screen to check that touch is working.
g. Power off device – Use device OS to power down device.
h. Remove C-cover.
Remove rSSD.
i.
IMPORTANT:
failure, see AB-cover Touch Calibration Retry section on
be carried out at this time and prior to complete re-assembly of device.
6. FPC RF Shield Installation – Install 2 new shield lids above the 4 AB-cover FPC connectors by orienting them
along the outline of the shield fences.
IMPORTANT:
hand shield has 2 rectangular embosses in the shape of connector heads and the right-hand shield has 3
rectangular embosses.
Prior to shield installation, visually inspect each shield to ensure that shield fingers are not bent such that
they impeded the installation process.
Push the shields vertically downwards onto the fences and snap into place. Ensure the shields are evenly
pressed along the entire perimeter of each fence and that the front shield prongs are pressed firmly
against the shield fence.
7.
Connect WiFi Antenna – Reconnect the left WiFi antenna cable (see illustration below).
8. RF Baffle Installation – Install 2 new RF baffles on top of the shield by peeling off the adhesive protector
sheet and snapping them into place near the back of the shields. Firmly press your finger along the top of the
RF Baffle wall to adhere adhesive to shield.
42
Calibration Failure – If calibration tool returns an error message that indicates calibration
Be sure to install the correct shield type onto the corresponding shield fence. The left-
page 57
for details on how to proceed. This must
M1179886
Advertisement
Table of Contents
