Table of Contents
Advertisement
‚ XLR 1 or 2 - Mic Backup
Use this setting to record audio from a microphone plugged into your URSA Broadcast G2
XLR 1 or 2 input at a lower level than the standard 'mic' recording. This can be used to avoid
audio clipping in the event of an unexpected increase in loudness. This feature will only be
available as a selectable item if the XLR 1 or 2 input switch is set to 'mic'.
‚ None
Use this setting to disable your audio channel.
Channel 1/2 Level
Use these sliders to adjust the recording levels of your chosen channel 1 and 2 sources.
Audio meters are included with each slider to help you set the correct audio level. These levels
will also update when you adjust the audio using the audio knobs on the ergonomic control panel.
To achieve optimum audio quality, ensure your audio levels do not reach 0 dBFS. This is the
maximum level that your camera can record, meaning that any audio that exceeds this level will
be clipped, resulting in distortion.
Pad XLR -20dB
The -20dB pad option gives you added control to further reduce the input gain levels on your
URSA Broadcast G2's XLR audio inputs when shooting in a loud environment even after your
input levels are already turned down.
Pad Cam Mic -13dB
The -13dB pad option gives you added control to further reduce the microphone input gain
levels on your URSA Broadcast G2's internal microphone when shooting in a loud environment
even after your input levels are already turned down.
Cam Mic Low Cut Filter
Tap this switch icon to enable the low cut filter for your camera's internal microphones. This filter
helps to reduce potential wind noise or low frequency rumbling that may occur in exterior
shooting conditions. Note that the 'pad cam mic -13dB' selector must be switched off for this
function to work.
Audio Settings 2
The second page of your URSA Broadcast G2's 'Audio' tab contains the following settings.
Settings
98
Advertisement
Table of Contents
