Connecting The Ri-101Mk.ii; The Rear Panel - Vitus Audio Reference Series Owner's Manual

2. CONNECTING

Connecting the RI-101Mk.II

Outputs
Speaker left
Speaker right
Ground/Earth
Preout XLR
Inputs
Input 1,2,3 XLR
Input 4,5 RCA
Power
Optional DAC/Streamer interface
AES in
S/PDIF in
Ethernet in
WIFI - dongle
12 | RI-101 Mk.II Owner's manual
Place the RI-101 Mk.II on its
shelf. Connect all the sources
to the inputs of the RI-101 Mk.II,
(labelled INPUT 1 to 5 on the
rear panel.)
The preout connectors can be
connected to a power amplifier
for biamping or an active sub.
Connect the Speaker output
of the RI-101 Mk.II.
Lastly connect the mains to
the amplifier, after you have
connected both inputs and
outputs.
ATTENTION: Never plug in/
unplug any cables within the
whole of the system while
the RI-101 Mk.II is operational.
Always set the RI-101 Mk.II into
standby mode before making
any system adjustments.
Spade/Banana
Spade/Banana
Spade/Banana
3 pin XLR
3 pin XLR
RCA
C13/C15 IEC
3 pin XLR
RCA
RJ45
USB a (male)

The rear panel

Input 1 Input 2 Input 3
PUSH PUSH PUSH
GND / EARTH
+
NEUTRIK NEUTRIK NEUTRIK
Caution
Caution
Use this connection with care
Connecting it to other units
This is a true balanced with impropper GND may
damage this unit. Such
under any circumstance damage will not be covered
connect (-) speaker output by warranty!
to ground.
Input 4 Input 5 / RIAA Preout
MAINS
-
Optional DAC interface
2. CONNECTING
Input 3 Input 2 Input 1
PUSH PUSH PUSH
+
NEUTRIK NEUTRIK NEUTRIK
Caution
This is a true balanced
under any circumstance
connect (-) speaker output
to ground.
Preout Input 5 / RIAA Input 4
-
Optional Headamp interface
Fuse
This is a true balanced amplifier, DO NOT connect the "–" output
(Figure 3) to any ground source, including chassis or signal ground,
this will damage the amplifier and invalidate your warranty.
Figure 3 "–" output
RI-101 Mk.II Owner's manual | 13