Starting / Stopping The Engine - Stihl SR 430 Instruction Manual

English
Stop position 0
Ignition is interrupted, engine stops. The setting
lever (1) is not locked in this position. It springs
back to the run position. The ignition is again
ready for operation.
Throttle trigger limiter position
Travel of throttle trigger can be limited in two
stages:
1
a 1/3 throttle
b 2/3 throttle
To disengage the travel limiter,
► Return the setting lever (1) to the run posi‐
tion F.
1)
Throttle lock
2
The throttle trigger (2) can be locked in any
required position.
To disengage the lock:
► Return the setting lever (1) to the run posi‐
tion F.
1)
Not in all versions, country-specific
14
1)
a
b
1

9 Starting / Stopping the Engine

9 Starting / Stopping the
Engine
9.1 Before Starting
► Close valve lever (1) for solution feed.
9.1.1 Additionally on SR 450:
► Close the metering lever (2) for dusting and
spreading mode.
9.2 Starting the Engine
► Observe safety precautions.
NOTICE
Start your unit on a clean, dust-free surface only
to ensure that no dust is sucked in.
► The setting lever must be on F
1
2
0458-454-8221-F