3. Lift the control panel from the 2 top tabs. (See
.) Position the control panel to
Control Assembly
the right.
4. Remove the control box cover. (See
Components.)
5. Disconnect the outdoor fan wiring at CN102 on
the drive board and remove all associated wire
ties. (See
Control Box Components.
CN102
6. Remove the 4 Phillips-head screws from the 2
top brackets that hold the fan shroud in place.
Remove the brackets.
7. Remove the 2 Phillips-head screws that hold the
fan bracket to the bottom of the chassis.
8. Remove the 4 Phillips-head screws from the
compressor side of the fan shroud.
Control Box
)
9. Remove the 4 Phillips-head screws from the
vent side of the fan shroud.
Fan Shroud
– 51 –
(Continued next page)