Current Lumination Tetra AL10 Series Installation Manual

Product Code: 74913
Description Code: GE060/MV/V12T1-A
(Tetra AL10 Series)
®
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Risk of electrical shock. Disconnect power before servicing or
installing product.
LED Driver Features
• Class 2 wiring per NEC Article 725 (SELV)
• IP54: Dry or damp location rated
• Conforms to the following standards
This Class [A] RFLD complies with the Canadian standard ICES-005. Ce DEFR de la classe [A] est conforme à la NMB-005 du Canada.
Note: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
WARNING/AVERTISSEMENT
Risque de choc électrique. Couper l'alimentation avant le dépannage
ou avant l'installation du produit.
Prepare Electrical Wiring
Electrical Requirements
• The LED driver must be supplied with 120/277V, 60Hz
or 240V, 50Hz and connected to an individual properly
grounded branch circuit, protected by a 15 or 20 ampere
circuit breaker.
Grounding Instructions
• The grounding and bonding of the overall system shall
be done in accordance with National Electric Code (NEC)
Article 600 and local codes.
ARCH024-Lumination-Tetra-AL10-Series-Driver-Installation-Guide
Installation Guide
ARCH024
Page 1 of 2
(Rev 06/07/23)