Current Lumination Tetra AL10 Series Installation Manual

Lumination
Product Code: 74601
Description Code: GE060/G/V12T1-A
(Tetra AL10 Series)
®
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Risk of electrical shock. Disconnect power before servicing
or installing product.
LED Driver Features
• Class 2 wiring per NEC Article 725 (SELV)
• IP52: Dry or damp location rated
• Conforms to the following standards
This Class [A] RFLD complies with the Canadian standard ICES-005. Ce DEFR de la classe [A] est conforme à la NMB-005 du Canada.
Note: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved.
Information and specifications subject to change without
notice. All values are design or typical values when
measured under laboratory conditions.
LED Luminaire
®
WARNING / AVERTISSEMENT
ARCH023-Lumination-Tetra-AL10-Series-Driver-79044-LED-Architectural-Lighting-Installation-Guide_R01
Risque de choc électrique. Couper l'alimentation
avant le dépannage ou avant l'installation du produit.
Prepare Electrical Wiring
Electrical Requirements
• The LED driver must be supplied with 120V, 60Hz
or 240V, 50Hz and connected to an individual
properly grounded branch circuit, protected by a
15 or 20 ampere circuit breaker.
Grounding Instructions
• The grounding and bonding of the overall system
shall be done in accordance with National Electric
Code (NEC) Article 600 and local codes.
Installation Guide
ARCH023
Page 1 of 2
(Rev 4/19/23)