Table of Contents
Advertisement
END OF THE PROGRAMME
When the programme has finished, the appliance
stops automatically. The acoustic signals operate (if
they are active). The display shows
The indicator of the Start/Pause
off.
The door unlocks and the indicator
1. Press button ON/OFF to deactivate the
appliance.
After five minutes from the end of the programme,
the energy saving function automatically
deactivates the appliance.
When you activate the appliance
again, the display shows the end of
the previous programme. Turn the
programme dial to set a new cycle.
2. Remove the laundry from the appliance.
3. Make sure that the drum is empty.
4. Keep the door and the detergent dispenser
slightly ajar to prevent mildew and odours.
5. Close the water tap.
DRAINING WATER OUT AFTER END OF
CYCLE
If you have chosen a programme or an option that
does not empty out the water of the last rinse, the
programme is completed, but:
•
The time area shows
shows the door locked
•
The drum still turns at regular intervals to
prevent creases in the laundry.
•
The door stays locked.
•
You must drain the water to open the door:
1. If necessary, touch the Spin
decrease the spin speed proposed by the
appliance.
HINTS AND TIPS
WARNING! Refer to Safety chapters.
THE LAUNDRY LOAD
•
Divide the laundry into: white, coloured,
synthetics, delicates and wool.
•
Follow the washing instructions on the laundry
care labels.
•
Do not wash white and coloured items together.
button goes
goes off.
and the display
.
button to
2. Press theStart/Pause
•
If you have set Rinse Hold
appliance drains the water and spins.
•
If you have set Night
drains the water
The option indicator Rinse Hold
3. When the programme is completed and the
door locked indicator
open the door.
4. Press the ON/OFF
to deactivate the appliance.
STAND-BY OPTION
The Stand-by function automatically deactivates the
appliance to reduce the energy consumption when:
•
You do not use the appliance for 5 minutes .
Press the button ON/OFF to activate the
appliance again.
•
5 minutes after the end of the washing
programme
Press the ON/OFF button to activate the
appliance again.
The display shows the end of the last
programme.
Turn the programme dial to set a new cycle.
If the dial is rotated to the "Reset" position
appliance automatically turns off in 30 seconds.
If you set a programme or an option
that ends with water in the drum, the
Stand-by function doesn't
deactivate the appliance to remind
you to drain the water.
•
Some coloured items can discolour with the first
wash. We recommend that you wash them
separately for the first couple of times.
•
Turn multilayered fabrics, wool and items with
printed illustrations inside out.
•
Pre-treat stubborn stains.
•
Wash stubborn stains with a special detergent.
•
Be careful with curtains. Remove the hooks and
put the curtains in a washing bag or pillowcase.
•
A very small load can cause balance problems
with the spin phase leading to excessive
vibration. If this occurs:
button:
the
the appliance only
disappears.
goes off, you can
button for a few seconds
, the
21
Advertisement
Table of Contents
