Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZWF944A2PW
Summary of Contents for Zanussi ZWF944A2PW
- Page 1 User Manual GETTING STARTED? EASY. ZWF944A2PW EN User Manual Washing Machine...
-
Page 2: Safety Information
VISIT OUR WEBSITE TO: Get usage advice, brochures, trouble shooter, service and repair information: www.zanussi.com/support SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage. -
Page 3: Safety Instructions
staff kitchen areas in shops, offices and other working – environments; by clients in hotels, motels, bed & breakfast and other – residential type environments; areas for communal use in blocks of flats or in launderettes. – Do not exceed the maximum load of 9 kg (refer to the •... -
Page 4: Electrical Connection
• Make sure that there is air circulation between • When unpacking the appliance, It is possible to the appliance and the floor. see water flowing from the drain hose. This is • When the appliance is in its permanent position, due to the testing of the appliance with the use check if it is levelled correctly with the aid of a of water in the factory. -
Page 5: Product Description
springs, washing drum, drum spider and related • Disconnect the appliance from the mains ball bearings, heaters and heating elements, electrical and water supplies. including heat pumps, piping and related • Cut off the mains electrical cable close to the equipment including hoses, valves, filters and appliance and dispose of it. -
Page 6: Technical Data
The rating plate reports the model name (A) , product number (B), electrical ratings (C) and serial number (D). Mod. xxxxxxxxx Prod.No. 910000000 00 000V ~ 00Hz 0000 W 00000000 TECHNICAL DATA Dimension Width/ Height/ Total depth 59,7 cm /84,7 cm /65,8 cm Electrical connection Voltage 230-240 V... -
Page 7: Information For Installation
INFORMATION FOR INSTALLATION CAUTION! Do not lay washing machine on its front. Positioning and levelling Adjust the appliance correctly to prevent vibration, 3. Put the appliance back into an upright position. noise and movement of the appliance when it Remove the power supply cable and the drain operates. - Page 8 4. To a stand pipe with vent hole - Insert the drain You can extend the drain hose to hose directly into a drain pipe. Refer to the maximum 400 cm. Contact the illustration. authorised service centre for the other drain hose and the extension.
-
Page 9: Installation On Suspended Flooring
FIXING PLATE KIT If you install the appliance on a plinth that is not an accessory supplied by ZANUSSI, secure the appliance in the fixing plates. Read carefully the instructions supplied with the accessory. -
Page 10: Special Features
CONTROL PANEL SPECIAL FEATURES • This appliance is designed with a self cleaning draining system, allowing light fluff fibers that Your new washing machine meets all modern fall off the clothes to be drained out with the requirements for an effective treatment of laundry water, in such a way that there is no need by the with low water, energy and detergent consumption customer to access this area for regular... -
Page 11: Dial And Buttons
DISPLAY Door locked indicator. Delay start indicator. The digital indicator can show: • Programme duration (e. g. • Delay time (e. g. • Cycle end ( • Warning code (e.g. FlexiTime bars level indicator. Drum clean indicator. Child safety lock indicator. Add garments indicator. -
Page 12: Permanent Extra Rinse
• Use this option to add a pre-wash phase at TEMP. 30 °C before the washing phase. When you select a washing programme, the This option is recommended for heavily soiled appliance automatically proposes a default laundry, especially if containing sand, dust, mud temperature. -
Page 13: Programme Chart
suitable for a full load of normally soiled garments. a quick cycle for a smaller lightly soiled garments (max. half load recommended). the shortest cycle to freshen up a small amount of laundry. The FlexiTime is available only with the programmes in the table. - Page 14 Programme Reference spin Default tempera- speed Programme description Maximum load ture Spin speed (Type of load and level of soiling) Temperature range range Denim 800 rpm 3 kg Special programme for Denim clothing 30 °C (1200 - with delicate washing phase to mini- 40 °C - Cold 800) mize colour fading and marks.
- Page 15 Programme Reference spin Default tempera- speed Programme description Maximum load ture Spin speed (Type of load and level of soiling) Temperature range range 60min EasyWash 1400 rpm 5 kg Cotton and fast-coloured synthetic items. 30°C (1400- 800 Complete washing programme that, in only 60°C - 30°C rpm) 60 minutes, washes the daily soiled laundry...
- Page 16 Programme ■ ■ ■ Drain & Spin ■ ■ ■ ■ ■ Rinse ■ ■ ■ ■ ■ ■ ■ Dark Colours ■ ■ ■ ■ ■ ■ CleanBoost ■ ■ ■ 14min Refresh ■ ■ ■ 30min Rapid 60min EasyWash ■...
-
Page 17: Acoustic Signals
SETTINGS ACOUSTIC SIGNALS If you deactivate the acoustic signals, This appliance has different acoustic signals, that they continue to operate when the operate when: appliance has a malfunction. • You activate the appliance (special short tune). • You deactivate the appliance (special short CHILD LOCK tune). -
Page 18: Filling The Detergent And Additives
FILLING THE DETERGENT AND ADDITIVES Compartment for prewash phase, soak programme or stain remover. Compartment for washing phase. Compartment for liquid additives (fab- ric conditioner, starch). Maximum level for quantity of liquid additives. Flap for powder or liquid detergent. Always follow the instructions that you find on the packaging of the detergent products, but we recommend that you do not exceed the maximum indicated level ( ). -
Page 19: Starting A Programme
2. To change the temperature and/or the spin 4. Touch the Start/Pause button again to start speed, touch the related buttons. the programme immediately. 3. If desired, set one or more options by touching the related buttons. The related indicators Changing the delay start after the countdown illuminate on the display and the given has started... - Page 20 There is also an alternative way of cancelling: When you activate the appliance 1. Rotate the selector knob to the "Reset" position again, the display shows the end of the previous programme. Turn the programme dial to set a new cycle. 2.
-
Page 21: Hints And Tips
If you set a programme or an option that ends with water in the drum, the Stand-by function doesn't deactivate the appliance to remind you to drain the water. HINTS AND TIPS WARNING! Refer to Safety chapters. THE LAUNDRY LOAD •... -
Page 22: Care And Cleaning
• The choice and quantity of detergent will • Normally soiled laundry may be washed depend on: type of fabric (delicates, woollens, without prewash in order to save detergent, cottons, etc), the colour of clothes, size of the water and time (the environment is protected load, degree of soiling, wash temperature and too!). - Page 23 Remove any foreign objects (such as metal clip, buttons, coins, etc) that you may find in the door seal, the inlet hose filter and the drum. Refer to 'Door seal with double lip trap', 'Cleaning the drum' and 'Cleaning the inlet hose and the valve filter' paragraphs.
-
Page 24: Cleaning The Inlet Hose And The Valve Filter
1. Open the drawer. Press the catch downwards 3. Make sure that all detergent residue is removed as indicated in the picture and pull it out. from the upper and lower part of the recess. Use a small brush to clean the recess. 2. -
Page 25: Emergency Drain
45° 20° EMERGENCY DRAIN 3. Put the two ends of the inlet hose in a container and let the water flow out of the If the appliance cannot drain the water, carry out hose. the same procedure, described in 'Cleaning the 4. - Page 26 • Make sure that the water tap is open. • Make sure that the pressure of the water supply is not too low. For this The appliance does not information, contact your local water authority. fill with water properly. • Make sure that the water tap is not clogged.
- Page 27 Problem Possible solution • Set the spin programme. The spin phase does • This problem may be caused by the clogged drain circuit. Please con- not operate or the tact the Authorised Service Centre. washing cycle lasts lon- • Adjust manually the items in the tub and start the spin phase again. ger than usual.
-
Page 28: Consumption Values
CONSUMPTION VALUES INTRODUCTION This user manual reports two different tables in order to favour a gradual passage from a regulation to the other: • Regulation EU 1061/2010, valid up to 28th of February 2021, is related to the Energy Efficiency classes from A+++ to D, •... - Page 29 Eco 40-60 pro- Litres h:mm °C gramme Quarter load 0.450 2:45 1351 1) Maximum spin speed. Power consumption in different modes Off (W) Stand-by (W) Delay start (W) 0.30 0.30 4.00 Time to Off/Standby mode is 15 minutes maximum. ACCORDING TO REGULATION 1061/2010 Approximate Remaining Energy con-...
-
Page 30: Environmental Concerns
Programme Litres h:mm °C Cottons 2.80 4:00 1400 90°C Cottons 1.85 3:40 1400 60°C Cottons 0.45 3:00 1400 20°C Synthetics 0.85 2:10 1200 40°C Delicates 0.30 0:50 1200 30°C Wool 0.30 1:05 1200 30°C 1) Reference indicator of the spin speed. 2) Suitable for washing heavily soiled textiles. - Page 32 WWW.ZANUSSI.COM/SHOP...