Table of Contents
Advertisement
CAUTION! Make sure there is no
damage to hoses and there are no
leaks from the couplings. Do not use
an extension hose if the inlet hose is
too short. Contact the service centre
for a replacement inlet hose.
1. Connect the water inlet hose to the back of the
appliance.
45º
45º
20º
20º
2. Position it toward left or right depending on the
positon of the water tap. Make sure that the inlet
hose is not in vertical position.
3. If necessary, loosen the ring nut to set it in the
correct position.
4. Connect the water inlet hose to the cold water
tap with 3/4'' thread.
WARNING! The inlet water shall not
exceed 25 °C.
Water drainage
The drain hose should stay at a height of no less
than 60 cm and not more than 100 cm.
8
You can extend the drain hose to
maximum 400 cm. Contact the
authorised service centre for the other
drain hose and the extension.
It is possible to connect the drain hose in different
ways:
1. The drain hose can be bent into U shape and put
around the plastic guide.
Buy accessories from authorised
supplier.
On the edge of a sink - Fasten the guide to the
water tap or to the wall.
Make sure that the plastic guide
cannot move when the appliance
drains and the drain hose end is not
immersed in the water. There may be a
return of dirty water into the appliance.
2. If the end of the drain hose looks like this (see
the picture), you can push it directly into the stand
pipe.
Advertisement
Table of Contents
